Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 81 / 318

Section 4 Control Definitions F103/4/5A Manual
www.rottlermfg.com
4-27
Repeat this procedure for each tool. Touch ALL of them off from the same point.
When running a Rottler program the cutting insert for each tool will reference the Vertical Zero the
operator set in the program and come into contact with the surface to be machined at the same vertical
value.
Applying Table of Tools to Rottler Programs
The use of the Table of Tools to specific Rottler programs such as Bore and Mill will be defined in Chapter
5 Operating Instructions.
Fixture Select
This is also a very powerful tool. It is not generally used in the Rottler Programs. It’s basic function is
to offset a program and table of tools a set distance on each axis (if desired) and run the same program
without resetting axis zero points.
For example, if you have to fixtures that are identical but are set at a different location on the table you
can set the difference values in the table of fixtures and run the program.
It is recommended this is not used unless you are a very experienced operator.