Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 117 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-30
Instructions for Small In-Line Blocks
The Dual Axis Table has the capability of holding small (less than 13 ½” from pan rail to head surface)
in-line cylinder blocks for resurfacing. This will require the use of parts from the 7119P Universal Head
Fixturing package.
Mounting Block to Table
There are two (2) methods for mounting blocks to the Table. Blocks with the main caps removed or
with the raised main bearings can be mounted directly to the table surface. Block with the main bearing
caps installed which are lower than the pan rail surface must be mounted using support blocks from the
Universal Fixturing package.
Blocks with Main Caps Removed or Raised Main Bearings
Remove any burrs from pan rails of block.
Locate cone washers on table to approximately center block in path of cutter-head and ‘hook’ the edge
of the pan rail in the rear. Clamp the block using clamp handle assembly. We suggest you install the stop
rod assembly on the left hand end of the block. This is an added safety precaution.
Check that all bolts and hold downs are tight. Loosen table clamp and level head surface of block in both
directions. Lock table clamp and recheck block for level.