Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 174 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-87
Programming Vertical Stops
To build a program you must set the axis stop. The stops that are used in the Line bore mode are X,Y,Z.
Programming X Stop
The Horizontal Zero was set .050” before the first Main Bore, so the first Horizontal stop will be 00.000.
Measure the distance between each main and enter it into the corresponding stop number.
Programming Y Stop (optional)
The in-out Zero is usually set and left to 0 when in Line Bore. In the rare case it is necessary to correct for
misalignment on the y-axis, or a special offset type bore..
Bore Z Stop Centerline
The first vertical stop is on the main bore centerline. The vertical zero was set on the bore centerline.
Therefore this stop will always be zero. This field should be used to account for minor variations in the
block, .0005 -.005.
Programming Bore Length
Measure the length of each Main Bore and enter that value into the corresponding length box
Deviation from main line.
Graph Probed Values
Used to give a visual picture of the actual main bore before and after