Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 151 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-64
Mill Operation
IMPORTANT: Do not move the machine In/Out with the Wedge on. The Wedge comes on automatically
when the Mill program is entered. If you need to move the machine In/Out to center on the work Piece
use the turn Wedge On/Off button at the bottom of the page to do so. Make sure the Wedge is back on
when you start the cycle.
This screen is used to set certain parameters the F103/4/5A will use to run the automatic cycle.
End
Horizontal End
This displays the current end stop value. To enter a new value press the display and a pop-up numerical
key pad will appear. Press the desired end stop value and then ENTER. This is the distance from where
the Horizontal Zero was set. You can move the fly cutter manually to the end of the cut and press the
SET button. This will automatically put the Horizontal End value in for you.
Amount Per Pass
This is the amount of material removed from the work piece on each pass of the cutterhead.
Vertical Start
This is the Vertical Position the machine will start cutting at. This value is usually Zero which is usually
the starting Deck Height.
Vertical End
This is the Vertical Position the machine will stop cutting at. It is the Total amount of material you want to
remove in the Milling process.