Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 146 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-59
Setting Vertical Clearance with 4th Axis
It is very important when setting your Vertical and Probe Clearance height that you be sure to account
for the Roll Over of the block from bank to bank. When in an automatic program the block will roll from
the Left Bank to the Right bank at the Left Bank Bore1 position. It will also rotate from the Bore1 position
when going from Right Bank to Left.
Table of Tools for 3 and 4th Axis Bore Mode
NOTE: The Table of Tools is not needed to run the Rottler automatic programs. It is
recommended that it not be used except by the advanced operator.
Building a Program with Table of Tools
Build the program as described above for 3 and 4 Axis programs using the same vertical zero locations.
Put the tools to be used into the Table of Tools as described in Chapter 2. In Bore mode you are not
referencing another vertical location such as the Crank centerline so the Z Touch off Location will remain
at zero.
Assigning Tools
Tools to be used in the boring operations are set on the Set Zeros page. To select a Tool, double click on
Tool # on the right side of the screen. This will bring up the Table of Tools window. Highlight the tool you
will be using, such as 2.9 Production Stub and select OK.
Do the Same to select the Probe you will be using, such as 100mm Probe.
NOTE: The Tool highlighted in red is the currently Active tool.