Ross CrossOver 16, Operator'S Manual

Page: 59 / 92

CrossOver 16 User Manual (v4.0) Advanced Operation • 4–15
7.
Use the
Type
knob to select the GPI output
level and trigger type. You can choose from the
following:
•
LowE
— The output level is
set high, and momentarily
goes low for the trigger.
• HighE — The output level is
set low, and momentarily goes
high for the trigger.
•
LowL
— The output level
toggles from the base high
level to the low level. The
output signal remains at this
level until reset
•
HighL
— The output toggles
from the base low level to the
high level. The output signal
remains at this level until
reset.
8.
If you selected either
LowE
or
HighE
in the
previous step, use the Dur knob to set the
length (in frames) that the GPI output remains
triggered.
Note:
• Edge triggered GPI outputs remain triggered for
the configured duration.
• Level triggered GPI outputs toggle between
latched and unlatched each time you press the
corresponding Wipe Pattern button.
• Changing the configuration of a GPI output pin
that is currently latched causes it to unlatch.
GPI Input Banks
Banks configured as GPI inputs have inputs assigned
as follows (Pin 1 is the top right pin when looking at
the GPI Port).
Figure 4.5 GPI Port
Note:
• GPI input pin assignments are not
user-configurable.
For More Information on...
• port locations, refer to the section “Frame Rear
Connections Overview” on page 1-3.
Triggering GPI Outputs
You can trigger GPI outputs manually or
automatically.
Table 4.5 GPI Port GPI Input Mapping
Pin Trigger
Bank 1
1 Dissolve Key 1
2 Dissolve Key 2
3 Dissolve Key 3
4 Perform Auto Transition
T
rigger
Duration
T
rigger
Duration
T
rigger
T
rigger
13 12 11 10 9 8 7 6 5 4 3 2 1
14 15 16 17 18 19 20 21 22 23 24 25
5 Perform Program / Preset Bus cut
6 Perform Key 1 cut
7 Perform Key 2 cut
8 Perform Key 3 cut
Bank 2
9 Perform Fade to Black
10 Set Aux Bus 1 to Input 1
11 Set Aux Bus 1 to Input 2
12 Set Aux Bus 1 to Input 3
13 Set Aux Bus 1 to Input 4
14 Set Aux Bus 1 to Input 5
15 Recall Memory 0
a
16 Recall Memory 1
a
Bank 3
17 Recall Memory 2
a
18 Recall Memory 3
a
19 Recall Memory 4
a
20 Recall Memory 5
a
21 Recall Memory 6
a
22 Recall Memory 7
a
23 Recall Memory 8
a
24 Recall Memory 9
a
Not Assigned to a Bank
25 Ground
a. Only memory registers from memory bank 0 can be recalled with a
GPI trigger.
Table 4.5 GPI Port GPI Input Mapping
Pin Trigger