Ross CrossOver 16, Operator'S Manual, Page: 15 / 92

CrossOver 16 User Manual (v4.0) Introduction • 1–5
Buttons
The buttons illuminate to indicate one of four states:
• Glow — When a button on the board is lit with the
Panel Glow color, it is in a resting state. All
buttons are lit with the Panel Glow color unless
selected, turned on, in use, or on-air.
• On-air — Source buttons corresponding to on-air
sources are red.
• Menu — A button is green when the associated
menu is displayed.
• On/Selected — Several buttons are On/Off
buttons. If the button feature is turned off, it is lit
with the Panel Glow color. If the button feature is
turned on, the button is lit with a brighter shade of
the Panel Glow color.
For More Information on...
• adjusting the panel glow, refer to the section
“Customizing the Panel Glow” on page 2-10.
Button Inserts
Insert films can be installed into most switcher
buttons. Insert films allow you to label specific
source buttons, control buttons, or replace the default
button names with those of a different language.
Installing Your Own Insert Films
All inserts must be cut to the dimensions indicated
for small (1) or large (2) buttons.
‘
Using insert films that do not meet the recommended
criteria may damage the button cap and diffuser.
Figure 1.7 Insert Sizing
To install switcher button inserts:
1.
Remove the Cap Assembly (1) from the Switch
Assembly (2) by grasping it firmly and pulling
away from the control panel surface.
2.
Remove the Lens (1) from the Diffuser (2) using
a common end micro screwdriver.
3.
Place the Insert Film (2) into the Lens (1) so the
readable side is facing up. The notches on the
sides of the Lens must be at the sides of the text
on the Insert Film.
4. Aligning the notches on the sides of the Lens (1)
and Diffuser (3), press the Lens and Diffuser
together until they click.
5. Aligning the notches on the sides of the Cap
Assembly (1) to the tabs on the side of the
Switch Assembly (2), press Cap Assembly down
onto the Switch Assembly with a rolling motion
until they click together.
Fader
The Fader is used to manually perform a wipe or
dissolve transition. Move the Fader handle from one
limit to the other to perform a transition.
Transitions
The progress of the transition is shown on the
Progress Bar to the left of the Fader handle. As the
Fader handle moves from one limit to the other, the
Progress Bar indicates the progress of the transition.
2
0.504"
0.444"
0.528"
0.468"
1
2
1
2
1
CUT
2
3
1
2
1