G A L A X Y ® A U R O U R A L S C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N G U I D E
99
Section 5 Application / Technical Notes
IP Address Firewall
It is possible to set webmin to deny or allow specific IP addresses access to the array. To do
this, expand the Webmin group on the left, then click on Webmin Configuration under this
group. A series of icons will appear on the right, as follows:
Left-click on the icon which reads IP Access Control. This brings up the following screen:
Notice the bubbles at the top of the table. If you check the left bubble (the default) – Allow from
all addresses, All IP addresses will be able to access this array. The other two bubbles are
used in conjunction with the text box below. You enter IP addresses into the text box. If you
then check the bubble which reads Only allow from listed addresses, then only IP addresses
listed in the text box will be able to access this array. If you check the right bubble Deny from
listed addresses, then any IP address except the ones listed will be able to access this array.
Once you have the screen set the way you would like, left-click on the Save button at the
bottom. To exit without saving, let-click on the Return to Webmin configuration link at the
bottom of the screen.
To return to the NumaRAID GUI, expand the Hardware category on the left, if it is not already,
and left-click on NumaRAID GUI.
