RCP Technik GmbH & Co. KG, Tarpen 40/Gebäude 7b, D-22419 Hamburg
Hotline: +49 (0)6 31/3 42 84 49
20
In order to automatically search for the wireless network of your router, click on
“Search“
below the entries.
Select the desired WLAN network from the list by marking it under “Selection” and click on
“Use“
. The settings then change
back to Wireless settings.
Enter the wireless network key of your router under “PSK” or “Key”. This should be stored in your router documents.
Click on “
Apply
“, to accept the changed settings. Next, restart the surveillance camera to accept the changes. The restart
takes about 2 minutes.
You can now remove the network cable between the surveillance camera and the router. Do, however, note that the surveil-
lance camera has a different local address through the wireless connection than when connected via the network cable. Once
restarted, the surveillance camera must be searched for using the program
Rollei SafetyCam Config
and opened through
“Browser“
.
5.6. Setting up the router
The surveillance camera is now set up in such a way that you can access it from your home network. You now have to set up
your router in such a way that access from the Internet is allowed. As in most cases, the router is protected against such access
by a Firewall, a separate access for the surveillance camera must be opened in the router. If your router supports the function
UPnP
, access is set up automatically. As the option UPnP is activated in the surveillance camera as a default setting, you can
test in the following manner whether automatic set-up to the Internet has been successful:
Open address
http://rolleicam.net/ip.aspx
in a Browser window.The public IP address of your home network will be displa-
yed. The software must installed on a computer connected to the same home network as the surveillance camera.