Advanced Settings f or P rinting and Cutting with Crop Mark s
4
Advanced
Functions
144
Correcting Misalignment f or P rinting and Cutting W hen Using Crop Mark s
1.
P erf orm the p rep arations bef ore the correction.
A
Mak e sure the [ AUTO ENV . MATCH ] menu item is set to " ENAB LE."
"
P . 13 9 " V i e w i n g t h e A u t o m a t i c E n vi r o n m e n t C o r r e ct i o n F u n ct i o n S e t t i n g s"
B
P erf orm bidirectional adj ustment.
"
P . 12 0 " C o r r e ct i n g f o r M i sa
l i g n m e n t i n B i d i r e ct i o n a l P r i n t i n g "
2.
P erf orm a p rinting test.
A
P ress [ MENU] .
B
P ress [ ] to disp lay the screen shown below.
MENU
C
P ress [
] , then [ ] to disp lay the screen shown below.
D
P ress [
] to disp lay the screen shown below.
E
P ress [ ENTER] .
The test pattern (C&C1) is printed and cut. The test pattern is printed at one locations on the media:
on the right edge of the media.
F
Check the test p attern (C& C1 ).
Check whether the printing position and the cutting position are aligned.
C u t t i n g p o si t i o n
P r i n t i n g p o si t i o n
P r i n t i n g p o si t i o n a n d cu
t t i n g
p o si t i o n a r e m i sa
l i g n e d .
P r i n t i n g p o si t i o n a n d cu
t t i n g
p o si t i o n a r e a l i g n e d .
If the printing position and the cutting position are aligned, no corrections are necessary.
If the printing position and the cutting position are not aligned, proceed to the next procedure.
