Roland TrueVIS SG-300, User Manual

Page: 118 / 200

Settings f or the Media H eating Sy stem
4
Advanced Functions
116
C
P ress [ ] to disp lay the screen shown below.
D
P ress [ ] or [ ] to select " P RINT" (p rint heater) or " DRY ER."
E
P ress [ ] to disp lay the screen shown below.
PRINT
0
DRYER
0
F
P ress [ ] or [ ] to select the temp erature.
You can also set the temperature to "OFF." When set to "OFF," the media heating system does not
operate at all.
P RINT H EATER: G eneral G uide f or Setting the Temp erature
PRINT
0
You use this mainly to improve ink adhesion and inhibit smudging. If the ink forms lumps or smudges,
raise the temperature. Note, however, that a temperature that is too high may degrade the media
or cause it to wrinkle.
DRY ER: G eneral G uide f or Setting the Temp erature
DRYER
0
When ink drying is poor, raise the temperature. Note, however, that a temperature that is too high
may degrade the media or cause it to wrinkle.
G
ress to con rm our entr
H
P ress [ FUNCTIO N] to go back to the original screen.
Descrip tion
With the default settings, simply switching on the power does not make the media heating system warm
up to the set temperature. The temperature rises to the set temperature when the media is loaded correctly
and [SETUP] lights. You can also make this setting in the software RIP. When you have made the setting in the
software RIP, the software RIP's setting is used.
Note: Depending on the usage environment, the temperature of the print heater or dryer may become higher
than the set temperature, but this does not represent a problem.