Roland SOLJET PRO4 XF-640, User Manual

Page: 72 / 196

2
Basic Operation
Outputting
70
You can make the setting in the software RIP for automatic media cutoff after printing or cutting has
finished. For information on how to make the setting, refer to the documentation for the software RIP
you're using.
Cut-off Operations
 Be sure to detach the media clamps. Performing cutoff with the media clamps remaining attached
may cause the operation to be interrupted due to detection of the media clamps.

If the media clamps are present on the machine when the setting to execute automatic cutoff of
the media is made on the computer, the media clamps are detected and no cutoff operation is
performed

Before you're performing cutoff, never use to pull the media back. Unless the end of the
media has been pulled out to a location to the front of the platen, cutoff may not be performed
smoothly.
Give Attention to Media Composition

For some types of media, cutoff is not possible.

Some types of media may remain on the platen after cutoff. If the media remains on the platen,
remove it by hand.