Roland SOLJET PRO4 XF-640, User Manual

Page: 179 / 196

An Error Message Appears
6
FA
Q
177
[SETUP SHEET AGAIN]
The media setup is canceled because two or more of the following conditions are present.

"EDGE" or "PIECE" is selected in [SETUP SEET], where media setup is done.

"AUTO DISPLAY is set to "ENABLE" (the screen for loading a preset is displayed at the time
of media setup).

P. 104, "Automatic loading of a saved preset when media is loaded"

In the loaded preset, "EDGE DETECTION" is set to "DISABLE" (detection of the leading and
trailing edges of the media is disabled).

P. 115, "Using Transparent Media"
When "EDGE DETECTION" is set to "DISABLE," you cannot select "EDGE" or "PIECE" in [SETUP SHEET]. For this
reason, the setting is canceled if two or more of the above conditions are present. If you want to select "EDGE"
or "PIECE," call a preset for which "ENABLE" has been selected for [EDGE DETECTION], or set [EDGE DETECTION]
to "ENABLE" before [SETUP SHEET].
[DATA ERROR CANCELING...]
Output was stopped because a problem was found in the data received.
Operation cannot be continued. Check for a problem with the connector cable or the computer, and redo the
operation from the step of loading the media.
[PINCHROLL ERROR INVALID LEFT(RIGHT) POS]
The left (right) pinch roller is positioned at a location where it does not pinch the media.
First, move the loading lever to the rear and move the left (right) pinch roller to the correct location.

P. 39, "Loading Media"
[PINCHROLL ERROR LOWER PINCHROLL]
was pressed without first lowering the pinch rollers.
Press any key to clear the error. Pull back the loading lever, then press .
The pinch rollers were raised while was illuminated.
The error is cleared automatically after a short wait. Never move the loading lever while printing is in progress.
[WRONG CARTRIDGE]
A cartridge that cannot be used was installed.
Remove the cartridge to clear the error. Use a cartridge of the specified type.