2
Setup of Media
Basic Operation
56
[Two shapes are peeled off separately]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure
8.
[Two shapes are peeled off together/backing paper is
also cut]
Press
to select [YES].
Press
to enable the setting.
Go to Procedure
.
Use
to adjust the blade force.
If two shapes are peeled off together
raise the blade force.
If backing paper is cut too
reduce the blade force.
Press
to enable the setting.
Cut the test pattern again. Check the result.
[Two shapes are peeled off separately]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure
8.
[Two shapes are peeled off together]
Press
to select [YES].
Press
to enable the setting.
Cut the test pattern again. Go back to the procedure
and set again.
For the individual setting method of this setting item and the description, refer to
P. 121, "Fine-tuning the
Cutting Conditions"
8.
Correcting Misalignment for Printing and Cutting
Press
to select [SET].
Press
to enable the setting.
The test pattern (P&C1) is printed and cut. The test pattern is printed
at three locations on the media: at the two edges and in the center.
CONTINUE ADJ. ?
[YES] DONE
CUT FORCE
50 gf 50 gf
REDO ADJ.?
YES [DONE]
Subtle misalignment between the printing and cutting positions may occur due to the thickness of
the media or the head height. We recommend making correction to match the media you're using.
PRINT-CUT ADJ.
[SET] NEXT
Current correction
value
Value to be set
Summary of Contents for SOLJET PRO4 XF-640
