2
Basic Operation
Outputting
66
Setting The Cutting Test And The Blade Force
For high-quality cutting, then before you perform actual cutting, we recommend carrying out a cutting test
to check the cutting quality for the media. Adjust the blade force depending on the cutting quality.
1.
Carrying out the cutting test
Press
to move the cutting carriage to the location
where you want to carry out the cutting test.
You can freely set the location for the cutting test.
Close the front cover.
Hold down
for one second or longer..
The test pattern is cut.
Peel off the cut shapes to verify the cutting quality.
[Two shapes are peeled off separately]
You do not need to perform the setting because the blade
force is appropriate.
[Two shapes are peeled off together/backing paper
is also cut]
Go to the next Procedure to set the blade force.
2.
Setting the blade force.
Press
.
Press
to select the value.
[Two shapes are peeled off together]
Raise the blade force.
[Backing paper is also cut]
Reduce the blade force.
Press
to enable the setting.
Go back to the original screen.
Pressing
enters the cutting configuration menu. You can also make the settings for other cutting
conditions in addition to the blade force. Refer to the following pages. Refer to the following pages.
P. 121, "Fine-tuning the Cutting Conditions"
FORCE
50 gf 50 gf
Rectangle
Circle
Summary of Contents for SOLJET PRO4 XF-640
