43
Appendix
What to Do If
The machine doesn’t work
Symptom
Points to check
Action
Refer to
The machine does not
output print data
Is the machine turned on?
Turn on the machine.
Has the connector cable come loose?
Connect the cable.
“Roland DG Start-up page”
http://startup.rolanddg.com/
Does the computer have enough disk
space?
The computer was unable to obtain the disk space required to output
data.
Increase the amount of free disk space by deleting unnecessary files,
etc.
—
I can’t print
Symptom
Points to check
Action
Refer to
The job drops into the
liquid material vat
Does the weight of the job exceed the
maximum printable resin volume?
Reduce the size of the object.
monoFab Player AM Help
Make the object lighter by reducing the thickness of areas where resin
is thick.
—
Is the area of the object in contact with the
platform too small?
Increase the area (shape) of the object in contact with the platform.
—
Increase the number of supports.
monoFab Player AM Help
Has the initial printing height of the
printing platform been adjusted?
Appropriately adjust the initial printing height.
Is the object’s center of gravity heavily
skewed?
Change the shape of the object so that the center of gravity is in the
center of the job.
—
Increase the number of supports.
monoFab Player AM Help
Summary of Contents for monoFabARM-10
