35
Maintenance
WARNING
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
WARNING
Be sure to perform operations as specified by the instructions below, and never touch any area not specified in the instructions.
The machine may move in an unexpected way, resulting in injury or burns.
WARNING
Never place a photo-curable resin container in fire.
Resin may flow out, catch fire, and spread fire to other nearby objects.
WARNING
Never use gasoline, thinner, or such material.
Doing so may cause fire.
CAUTION
When handling resin, wear rubber gloves.
Do not allow resin to come into contact with the skin.
Perform Maintenance after Use
After using the machine, clean the liquid material vat and the printing platform.
NOTE
•
When using ethanol for maintenance, only use it where instructed. Failure to do so may result in color changes or deformation.
•
Be careful of fire when using ethanol.
•
Do not leave the machine with resin on the liquid material vat or printing platform. Resin will cure and you will no longer be able to use the liquid material vat
or printing platform.
Summary of Contents for monoFabARM-10
