Output (Printing)
33
MEMO
An ultrasonic cleaner (commercially available) can also be used for washing.
Ultrasonic cleaner
(Commercially available)
Ethanol (Commercially
available)
Beaker (Commercially
available)
Water
Job
1.
Put the removed job in a beaker.
2.
Put ethanol in the beaker.
Lower the removed job into the ethanol until it is entirely submerged.
3.
Put water into the ultrasonic cleaner container and partially submerge the beaker in it.
4.
Wash in the ultrasonic cleaner (1 to 2 minutes).
MEMO
•
For information on how to use the ultrasonic cleaner, refer to the instruction manual included that it came with.
•
Use an ultrasonic cleaner that produces a frequency of 40 to 45 kHz.
•
If the ethanol in the beaker changes color, replace it and wash the job again.
5.
Stop the ultrasonic cleaner and remove the job.
6.
Wipe the ethanol off the job.
Summary of Contents for monoFabARM-10
