Output (Printing)
24
Check that there is no dirt on the printing platform
Before starting printing, check that there is no dirt or foreign matter on the printing platform (such as fragments remaining from the last printing operation).
If there is dirt or foreign matter, wash the printing platform.
For details, refer to
Adjust the initial printing height (Z0)
When setting the liquid material vat for the first time or when replacing the liquid material vat, it is necessary to adjust the height at which the job starts to be made
in the liquid material vat.
1.
Using the included hexagonal wrench, loosen the Z0 adjustment screws (4 locations).
Loosen each screw so that around 2 mm of the shaft is visible, and check that it is possible to move the printing platform up and down by hand.
Z0 adjustment screw
(Both sides of printing platform: 4 locations)
NOTE
Always loosen the Z0 adjustment screws. If you proceed to step 2 without loosening the Z0 retaining screws, a large load will be applied to the liquid material vat,
printing platform, and Z axis unit, which may result in damage.
2.
In monoFab Player AM, on the
[Print]
tab, click the
[
]
button on the screen.
The printing platform descends to the bottom of the liquid material vat.
Summary of Contents for monoFabARM-10
