Acquisition and Waveform Setup
R&S
®
RTM20xx
22
User Manual 1317.4726.02 ─ 01
●
Running one acquisition or a given number of acquisitions
Prerequisites:
●
Probes are connected.
●
Vertical and horizontal settings are adjusted.
●
Triggering is set.
●
Channels to be acquired are turned on.
To start and stop continuous acquisition
1. Check if the trigger mode is set to "Normal". The trigger mode is shown in the top
information bar.
If not, press the MODE key on the front panel to toggle the setting.
2. Press the RUN CONT key to start acquisition.
The acquisition starts if a trigger occurs.
3. To stop, press the RUN CONT key again.
The acquisition stops immediately.
To acquire a limited number of acquisitions
1. Press the ACQUISITION key in the HORIZONTAL area of the front panel.
2. Select "Nx Single" and enter the number of acquisitions.
3. Press the RUN N
×
SINGLE key on the front panel.
You can stop the acquisition before it is finished by pressing the key again.
2.3 Reference for Waveform Setup
2.3.1 HORIZONTAL Controls
Time base settings adjust the display in horizontal direction. Use the rotary knobs in the
HORIZONTAL functional block for setting.
Reference for Waveform Setup
