Operating Basics
R&S
®
EVSF1000
35
Getting Started 1178.6404.02 ─ 05
Measurement information for each receiver board (RX1/RX2)
In addition to the current measurement mode, measurement-specific information
is provided.
For example, for "ILS LOC" mode:
●
"CH"
: Receiver channel
●
"F"
: Receiver frequency
●
"DDM"
: ILS DDM
●
"SDM"
: ILS SDM
●
"LEV"
: Currently measured power level
●
"ID"
: Decoded ID of transmitter
Network settings (NET)
●
"DHCP"
: DHCP usage
●
"IP"
: IP address of the R&S
EVSF1000
●
"CLIENT"
: IP address of connected client
Operating status of the R&S
EVSF1000
●
"HW"
: Hardware status("OK"/"ERROR")
●
"GPS"
: Availability of GPS signal
Current date and time
6.2
Basic Connection Settings
To operate the R&S
EVSF1000 from a remote PC, you require connection infor-
mation.
By default, the R&S
EVSF1000 is set to use the dynamic host configuration proto-
col (DHCP), so the IP address is assigned automatically. The assigned IP
address and DHCP state of the R&S
EVSF1000 is provided in the mini display on
the front panel.
Use this IP address for the initial connection from a remote PC to the
R&S
EVSF1000.
Basic Connection Settings
