Preparing for Use
R&S
®
EVSF1000
16
Getting Started 1178.6404.02 ─ 05
Figure 4-1: Perforations for installation in the rack
a) Fasten 3 screws through the perforations on the left as shown in
b) Fasten 3 screws through one of the two rows on the right.
c) Tighten all screws with a tightening torque of 1.2
Nm to secure the tray in
the rack.
3. Connect the ARINC connector of the tray to the board power supply and any
other devices required for signal input or output, such as the receiving
antenna, the GPS receiver, or the PPS signal.
For a description of the pin assignment, see
.
4. Place the bottom of the R&S
EVSF1000 on top of the installation tray.
5. Insert the ARINC connector of the tray to the female connector on the
R&S
EVSF1000.
Setting Up the Product
