Rohde & Schwarz 1330.0008.02, Getting Started

Page: 28 / 45

Instrument Tour
R&S
®
EVSF1000
28 Getting Started 1178.6404.02 ─ 05
● Trigger In (R&S EVSF1-B4 Only) ....................................................................32
● IP-Address Select (R&S EVSF1-B4 Only) ...................................................... 32
● Device ID .........................................................................................................32
5.2.1 Power Supply
XLR connector for an external DC power source (11 V DC to 32 V DC).
For details, refer to "Connecting to power" on page 7 and Chapter 4.5, "Connect-
ing to Power" , on page 18.
5.2.2 RX1 In / RX2 In
The RX input connectors are 50
Ω
N connectors. Use the RX inputs to connect a
receiving antenna (max. +13 dBm) to the R&S EVSF1000 for RF signal input.
5.2.3 LAN (Ethernet)
Operate the R&S EVSF1000 remotely using the LAN connection (Fast Ethernet).
The LAN connection can also be used to stream measurement data (TCP port
8000; for I/Q data: 8001 (RX1) or 8002 (RX2)). The data transfer rate is 100
Mbit/s.
Using a VNC viewer, you can perform hardkey and softkey tasks on the
R&S
EVSF1000 in a LAN via shortcuts on a remote keyboard.
For details about remote control, see the "Remote Control" chapter in the
R&S
EVSF1000 user manual.
5.2.4 RS-232 GPS
2-port RS232, 9-pin D-Sub connector for a GPS receiver providing NMEA proto-
col data. The NMEA protocol data is displayed and stored with the recorded data
(requires option R&S
EVSG-K20).
If R&S EVSF1-B4 is installed, the RS-232 GPS interface is integrated in the
ARINC connector (see Chapter 5.2.6, "Optional ARINC Connector (R&S EVSF1-
B4)" , on page 29).
Rear Panel