Rohde & Schwarz 1330.0008.02, Getting Started

Page: 21 / 45

Preparing for Use
R&S
®
EVSF1000
21 Getting Started 1178.6404.02 ─ 05
2. Disconnect the AC power supply.
4.6 Starting and Shutting Down the R&S EVSF1000
The R&S EVSF1000 does not have a power (On/Off) switch. When you apply
voltage to the power supply connector, the R&S EVSF1000 starts immediately.
To shut down the R&S EVSF1000, disconnect it from the power supply. Note the
information concerning power interruption provided in Chapter 4.5, "Connecting to
Power" , on page 18.
4.7 Connecting Devices for Signal Input and Output
1. Connect the RF input connector (RX1 IN/RX2 IN) with the receiving antenna
(see Chapter 5.2.2, "RX1 In / RX2 In" , on page 28).
2. Connect any other required connectors for input or output, such as GPS or
PPS signals (see Chapter 5.2.4, "RS-232 GPS" , on page 28 and Chap-
ter 5.2.5, "PPS In" , on page 29).
4.8 Connecting to LAN
You can connect the instrument to a LAN for remote operation via a PC. For
details on the connector, see
Chapter 5.2.3, "LAN (Ethernet)" , on page 28.
Provided the network administrator has assigned you the appropriate rights and
adapted the Windows firewall configuration, you can use the interface, for exam-
ple:
●
To stream measurement data from the R&S EVSF1000 to a connected device
●
To access or control the measurement from a remote computer using a VNC
client
●
To connect external network devices (e.g. printers)
Connecting to LAN