Rohde & Schwarz 1330.0008.02, Getting Started

Page: 15 / 45

Preparing for Use
R&S
®
EVSF1000
15 Getting Started 1178.6404.02 ─ 05
4.4.1 Mounting the R&S EVSF1000 in a Rack
The R&S EVSF1000 is meant for use in a flight inspection plane or a drone. For a
stable setup, you can connect the R&S EVSF1000 to an optional installation tray
that you insert in the flight inspection rack.
Using the connector plate, you can remove and replace the R&S EVSF1000
quickly and easily. While the tray remains connected to the aircraft permanently,
you can remove the R&S
EVSF1000 quickly and easily, without having to discon-
nect all cables from the instrument individually.
This setup requires an R&S EVSF1000 with the following options:
●
Slide-in hardware (R&S EVSF1-B4)
●
Installation tray with connector (R&S EVSF1-Z1)
The 60 mm perforations allow you to mount external fans to the tray.
To prepare the rack
1. Observe the requirements and instructions in "Setting up the product"
on page 6.
2. NOTICE! Insufficient airflow can cause overheating and damage the product.
Design and implement an efficient ventilation concept for the rack.
To mount the R&S EVSF1000 on an installation tray
1. Insert the installation tray into the flight inspection rack. Make sure it lies in the
rack straight and securely.
2. Fasten the tray in the rack by inserting 5 mm flat-head screws from the top of
the tray through the rack. Use only the indicated perforations for rack-mount-
ing to ensure the mechanical strength of the tray.
Setting Up the Product