MobiLink IP
CALL CONTROL
MobilinkIP_Usermanual-sw1.2.21_revGen.doc
Page 142 of 188
This special mode of operation stops the main application and leaves only the kernel operating, in
order to frees up the memory of the equipment for the new firmware, allowing you to perform easily
and safely the upgrade of software. Not only is the application stopped, but its Flash memory is
dismounted, to prevent interference or corruption. This can bee seen on the outside of the case of
MobiLink: only the STATUS indicator is blinking, showing network activity, the LEDs for Mobile1 and
Mobile 2 are turned off.
Since the phone exchange application, during the updating process, MobiLink IP is not available for
routing VoIP and mobile calls.
Also, if an error occurs during software update and the image file gets corrupted, the equipment will
automatically restart in System mode, allowing you to load a firmware image which is good.
The Upgrade configuration page is simplified, containing just a few elements – MobiLinkIP is
operating in System (Kernel) mode only.
There are only two pages available, NETWORK and SYSTEM.
Network shows the state of the network, here you can’t perform changes.
