MobiLink IP
CONNECTING THE DATA CABLES
MobilinkIP_Usermanual-sw1.2.21_revGen.doc
Page 19 of 188
For Ethernet network connection:
Use standard UTP network cable (CUT 5) fitted with RJ45 connectors at both ends.
The cable can be either straight-through or crossover, since the MobiLinkIP is auto-
crossover.
One short length of RJ-45 cable is supplied with the MobiLink IP device. Use either a
10Base-T or a 100Base-T connection.
Figure 4: Connecting the LAN cable (UTP- CAT5)
The network cable is to be inserted with one end into the RJ-45 socket of the MobiLinkIP
device labeled
ETH
. The opposite end of the UTP cable can be inserted directly into a PC or
in switches or hubs. The STATUS indicator LED of the MobiLink case will light up showing
physical connection and will blink to indicate data traffic on the respective Ethernet interface.
Power supply:
To power the MobiLink IP unit, insert the jack of the power supply adapter into the supply
connector. Do
not
yet plug the adapter into the 230V
A.C.
mains outlet on the wall. The special
adapter from Rohde & Schwarz Topex S.A which is part of the MobiLinkIP package, supplies
the voltage required to power the equipment. It is an external power supply adapter.
Note: The adapter is the disconnection device (there is no POWER switch), so the 230 V
AC
socket-outlet shall be installed near the equipment and shall be easily accessible.
