MobiLink IP
CALL CONTROL
MobilinkIP_Usermanual-sw1.2.21_revGen.doc
Page 117 of 188
Examples:
An incorrect setting of the net mask to 24 lets only the final
group of figures available for connection :
As consequence, the incoming call won’t be able to connect, no interface is chosen, and you can see
as reason for ending the call “ACL_REJECT”:
This ‘ACL_REJECT’ is the abbreviation for Access list reject, and it means that the source of call has
not been added into your 'access in" table. When you set the correct value for the Netmask (16), the
incoming call will be accepted, and a normal phone conversation may take place:
6.7.4 Incoming Calls
Settings for the incoming calls, that means calls which come in through the mobile interfaces of the
equipment:
Here there are only two rows that can be edited - it cannot be deleted or more rows added to it. Each
row sets the rules for one GMS module – interfaces Mobile 1 and respectively Mobile 2:
Define the rules for calls coming in from the mobile networks.
For each of the two Mobile interfaces one can choose
Enable
to activate it, then select the type
(
Like
),
Mode
of routing (action to be taken) and
Target
(destination).
First click
Edit
to start editing the specific row, then
Exit
to get out or
More
to reach additional
settings, and finally
Save
the settings:
