Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 24 / 104

24 Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019
Chapter 3 Operate the Terminal
2.
Use a Torx T10 screwdriver to remove the three screws that secure the back
cover.
3.
Carefully lift off the back cover and set it aside.
Figure 1 shows the main circuit board of the MobileView 2711T terminal with
the back cover removed.
Figure 1 - Printed Circuit Board (PCB) with Back Cover Removed
TIP The ‘Image Applied’ label on the back cover was part of the
manufacturing process. Therefore, you can remove and discard this
label.
IMPORTANT Use the reset button when MobileView 2711T terminal functionality ‘locks up’
and you cannot restart from the terminal-desktop screen.
Back Cover
Connection
Cable
Cable Connector S3 to
PCB Connector ETH
(Communication Interface)
SD Card™
(1)
Circuit Board
Serial No. Label
Cable Channel
(1 of 2)
Cable Connector S2 Connects to
PCB Connector S1 (Power and
Safety Connections)
Reset
Button
Cable channel that is used is
only for example. Use channel
that is best suited for your
application.
Cable Channel
(2 of 2)
(1)
The 2711T-T10I1N1-TC MobileView terminal does not have this feature.
(2)
For first generation terminals, this connection is for a push button or key switch connection. For second generation terminals, this connection is
for an illuminated push button.
Cable Connector S4 Connects
to PCB Connector S2
(2)