Rockwell Automation Allen-Bradley MobileView 2711T-VMBRACKET, User Manual

Page: 42 / 104

42 Rockwell Automation Publication 2711T-UM001E-EN-P - March 2019
Chapter 4 Install and Operate the Junction Boxes
You can slide the IP65 junction box onto the longer screw bosses of the mounted
back plate; no screws are needed.
Wire the 2711T-JBIP65DC1 Junction Box
To wire the 2711T-JBIP65DC1 junction box, perform the following steps.
1.
See Figure 8 on page 43 to determine the appropriate cable outlets for the
wires to be installed.
2.
Remove the cable glands from the cable outlets at the bottom of the
junction box that you plan to use.
3.
With a small flat-head screwdriver, remove the black plugs from the seal
rings that you plan to use.
4.
Place the corresponding seal rings over each wire.
5.
Place the corresponding cable gland over each wire.
6.
Feed each wire through the corresponding cable outlet.
7.
See Figure 9 on page 44 to attach each wire to the appropriate terminal.
8.
After all wires are attached, hand-tighten the cable glands to secure the
wires.
TIP The 2711T-JBBKCOVER back cover plate also has the longer screw bosses.
SHOCK HAZARD: When the back plate is removed, the circuit board inside the
junction box is sensitive to ESD.
Use an anti-static wriststrap connected to the work surface, and properly grounded
tools and equipment.
IMPORTANT To maintain the protection class, any unused cable outlet must be
sealed with a black plug.
IP65
Junction Box
Longer
Screw
Boss
Longer Screw Boss
Mounted
Back Plate