Robur Roburbox100, Installation And Use Manual

Page: 72 / 84

RB100 : Installation and Use Manual
66 Ed. 06/2014 – FW version 1.002
10. enter:
a. 0 for analogue input (0-10 V);
b. 1 for digital input with remote setpoint;
c. 2 for digital input with local setpoint;
11. click to confirm value entered.
For selecting analogue parameters to be setting afterwards, refer to paragraph 1.4
”OPERATING TECHNICAL FEATURES” point “Inlet configured as analogue
setpoint”.
If “analogue (0-10V)” input type is set up:
1.
position on parameter 64 and click, the number on display flashes;
2. enter temperature corresponding to max setpoint (10 Volts);
3. click to confirm value entered;
4.
position on parameter 65 and click, the number on display flashes;
5. enter temperature corresponding to minimum setpoint (0 Volt);
6. click to confirm value entered;
7. position on parameter 66 and click, the number on display flashes;
8. enter temperature corresponding to OFF request (off);
9. click to confirm value entered;
10. position on parameter 67 and click, the number on display flashes;
11.
enter setpoint resolution;
12. click to confirm value entered;
13. rotate knob until E appears for exit menu;
14. rotate knob until E appears for return to main page (leftmost point
flashing).
If “digital with remote setpoint” input type is set up:
1. setpoint is set up on DDC (DDC Use and Programming Manual: D-LBR 246);
2. rotate knob until E appears for exit menu;
3. rotate knob until E appears for return to main page (leftmost point
flashing).
If “digital with local setpoint” input type is set up:
1. position on parameter 68 and click, the number on display flashes;
2. enter setpoint temperature that board sends to DDC upon request;
3. click to confirm value entered;
4. rotate knob until E appears for exit menu;
5. rotate knob until E appears for return to main page (leftmost point
flashing).