Robur Roburbox100, Installation And Use Manual

Page: 54 / 84

RB100 : Installation and Use Manual
48 Ed. 06/2014 – FW version 1.002
Adjustment of main operating parameters
To operate appliance commissioning, the operations below must be performed according
to the sequence specified.
•
Access to panel where appliance is installed.
•
If off, turn on RB100 from power switch set by installer upstream of it.
To adjust operating parameters of the whole plant:
•
refer to SECTION 5: BOARD SETTINGS for parameter setting on RB100 interface.
•
refer to DDC manual for setting parameters of control panel.
Configuration of Direct Digital Controller (DDC): for adjustment of plant operating
parameters depending on user’s needs, refer to “DDC Use and Programming
Manual (D-LBR 249)” delivered with it.
When turned on for the first time, an operating code could appear on RB100
display (and/or on DDC display).
If operating code is issued by RB100, see the list of codes in APPENDIX on page
72; if operating code is issued by DDC, se the list of codes in "DDC Installation
Manual (D-LBR 273)" (delivered with it).
The positive result of commissioning only CERTIFIES proper operation of
appliance (and DDC).
It does CERTIFY plant compliance with standards enforced.
RB100 devices do not need special maintenance, except for normal cleaning at
regular intervals.