Robland Z400 EL, Manual

Page: 31 / 72

Z400-serie V0119
31
English Deutsch
Basic settings of a Panel saw
The basic settings of the machine are done in the factory. It is possible that during transportation and
while placing the machine, these setting need small adjustments. This can only be done by qualified
technicians.
1. Movement of the sliding table
The clearance between the under and upper profile of the sliding table is set by setting screws inside
the under profile. To adjust these, you must take off the covering plate Z1431 (fig.35.1), so you can
slide out the black covering strip (fig36.3). Now you’ll see the hexagon bolts.(fig.37.4) These need to
have light tension. If the tension is to light, you’ll get a unprecise sawing image, too much tension,
and the sliding table will have movement issues. Once the settings are adjusted, you slide the strip
back in and cover the profile back with Z1431.
Fig.35 Fig.36 Fig.37
2. Damage on the round bars of the sliding table
After long use or overload, it is possible that the round bars in the profile are damaged. To solve
this, you must loosen bolts Z1477, slide out the round bars approximately 5-10mm and turn them a
couple degrees. Slide the round bars back into the profile and tighten bolts Z1477. Check clearance
and lining of the sliding table afterwards
Fig.38
Fig.39
3. Replace the cleaning sponges of the sliding table.
Remove the end stop (fig. 40.1) from the trolley. Carefully move the top profile until the sponges are
visible (fig. 41). Replace the sponges (fig. 41.3) and reassemble the end plug.This procedure can also
be used to replace the balls in the ball cage.