24
V0119
Z400-serie
English
Deutsch
beam forward so that it is free from the support point (4). Now the fence can be moved at an angle.
The angle can be read on the measuring scale (7). Now pull the fence backwards until the stop (5)
falls into one of the notches on the index plate (8). Now you are sure of angle and length. Now the
clamping screws (2 and 6) can be fixed again.
Fig.18A
Fig.18B
Adjusting the cross-cut fence
(Fig.19-20-21)
ATTENTION!
To move the flip stop, loosen the clamping lever (2) at maximum ¼ turn. If it is further
loosened, the digital readout can lose its signal and thus indicate wrong values.
All measuring tapes are factory calibrated and the measure is read directly at the index (fig. 19.1).
The optional digital read out, or the normal standard stop, is calibrated as follows: put the 300 mm
calibration gauge
(Z1253) against the cross-cut fence and the saw blade tooth.
Now slide the digital stop up against the gauge and push << F and SET >>.
The read out is now automatically set at 300mm.
In order to check if the normal measuring tape matches the 300 mm at the index (fig.19, 1),
Make a test cut by putting both flip stops at any given position and check if the obtained measures
are correct.
When using the telescopic part of the cross-cut fence (up to 3000 mm) unlock the handle (fig.20.1)
And slide out the extension. Reading is done on the fixed part of the cross-cut fence, or on the
optional digital read out.
Fig.19
Fig.20
Summary of Contents for Z400 EL
Page 71: ...Z400 serie V0119 71...
Page 72: ...72 V0119 Z400 serie...
