Robland Z400 EL, Manual

Page: 9 / 72

Z400-serie V0119
9
English Deutsch
Starting the machine
(Fig.5-6)
Set main switch (1) to “1” to energize the machine (fig. 6.1).
For model Z400 fig (5A) and model Z400 EL fig (5B), for model Z400 X1 fig (5C) and Z400 X3, fig (5D).
Start the main engine (white button) and stop (black button) with the button (3).
The scorer motor is started by pushing the button (4); this is only possible with the main saw motor
running.
The upper white button starts the engine, the lower black button stops the engine.
When the emergency stop (1) is pressed, both motors are switched off. The main saw motor is
equipped with an automatic brake which slows down the motor within 10 seconds as soon as the
machine is shut off.
ATTENTION:
When the machine access door is open, the saw blade cover is open, or one of the emergency
stops is pushed in, the machine cannot be started.
If a saw blade> 350 mm diameter is mounted, the scoring blade must be disassembled.
ATTENTION! Also the flange where the scoring blade is mounted must be removed, if it does
not, it can come loose and cause serious injuries, or damage the saw blade, which can also
cause serious injuries.
By means of the lights (2) the set speed can be read before starting (only for CE version).
All fuses are located inside the electrical panel and each time this panel is opened the machine
has to be disconnected from its power supply.
Fig.5A Fig.5B
Fig.5C Fig.5D