20
V0119
Z400-serie
English
Deutsch
Use and adjustment of the riving
knife
(Fig.10-11)
The machine is equipped with two riving knives for the use of sawblades from 300 to 500 mm.
The riving knife has to be adjusted in such a way that over its entire length the gap between sawblade
and riving knife does not exceed min.3 mm and max.8 mm.
The riving knife can be adjusted in both vertical and horizontal direction.
The height setting has to be adjusted in such a way that the highest point of the riving knife never
exceeds more than 3 mm above the highest placed sawblade tooth.
After height adjustment always lock the central bolt (3) at a torque of 60 Nm. The 4 adjustment
screws (2) are used for the exact setting of the riving knife in line with the sawblade.
For slotting or grooving the riving knife has to be adjusted in such a way that the upper part of the
riving knife is never set lower than the highest saw tooth in use.
Never remove this riving knife. Kickbacks are severe and very dangerous.
Never remove this riving knife. Kickbacks are severe and very dangerous !!
Fig.10
Fig.11
Lower sawblade cover
In the event of a saw blade change, the sliding table must be pushed fully to the rear in order to be
able to open the saw blade cover.
The sawblade cover is held by 2 magnets.
If the cover is open, the saw cannot be started.
Summary of Contents for Z400 EL
Page 71: ...Z400 serie V0119 71...
Page 72: ...72 V0119 Z400 serie...
