4
V0119
Z400-serie
English
Deutsch
plastic coating. The processing of plastic sheets and plastic is permitted with adapted saws. The
machining of ferrous and non-ferrous metals is strictly forbidden. In order to be able to maintain
the indicated sound values, all protective caps and means provided on the machine must be used.
This also applies to the dust emission and means that the machine must be connected to a dust
extraction system, whose air flow rate measured at the extraction opening on the machine is at least
20 m / sec. amounts.
Normal and prohibited use
The panel saw is designed for the following work and is equipped with protective devices for these
processes only. It is not designed to work materials such as ferrous or non-ferrous metals, work
different from that stated below is prohibited.
-
Ripping with the parallel saw fence with/without the sawblade tilted and the fence upright or in
the low position.
-
Right-angled or mitre cuts with the 90° fence mounted to the sliding table with tilted or vertical
sawblade.
-
Cross-cutting workpieces using the adjustable stop on the 90° fence.
-
Cutting panels or solid wood on the sliding table.
PROHIBITED USE
Following tasks are prohibited on the panel saw:
-
submerged cuts by removing the riving knife and/or guard;
-
all types of cuts without using the table saw fence, the 90° fence or sliding table; Cutting large
workpieces that exceed the machine capacity without using aids such as roller supports.
REMAINING RISKS
The most important risks on the panel saw are:
-
unintentional contact of the hand with the saw blade;
-
contact with the saw blade during the stop time of the saw blade (10 sec).
-
recoil of the workpiece or recoil of parts within the workpiece
-
tilting of the workpiece due to insufficient support.
-
Injuries due to tool breakage or parts that break off the tool.
-
Injuries in the non-secured area between the machine table and the saw blade during sawing
parts.
-
Risk of pinching and crushing between the parallel fence and the sliding table
-
Risk of pinching and crushing between the parallel fence and the saw blade, riving knife and saw
blade.
-
When moving the sliding table, there are risks for clamping, pinching and crushing. Only use the
handle to move the sliding table.
-
When cutting plastics, there is a risk of the release of harmful substances.
-
Risks due to changes made to the machine by unauthorized personnel.
-
Risks for the machine, tools and safety equipment when tilting the blade while the saw blade is
rotating.
-
Risks for the machine, tools and safety equipment when setting the parallel fence with rotating
saw blade.
SOUND REDUCTION
-
The type and condition of the saw blade is important to keep the noise level as low as possible.
-
The material and the position of the safety devices are important for reducing the noise level.
Using the correct speed of the saw blade for the type of material will reduce the noise level.
-
The above does not mean that no additional protection measures such as hearing protection
should be used.
Summary of Contents for Z400 EL
Page 71: ...Z400 serie V0119 71...
Page 72: ...72 V0119 Z400 serie...
