Robland Z400 EL, Manual

Page: 27 / 72

Z400-serie V0119
27
English Deutsch
Mounting of the roller support
option
(Fig.31)
Put the hinge plate (1) of the roller support onto the frame using the bolts (2). The roller has to be
adjusted to the height of the saw table using the lower stop ring.
The whole support can be lowered and can be swung aside after opening the knob (4). If the roller
support has to be taken off, simply lift it off its hinges.
Fig.31
Using the saw guard
(Fig.26A-26B-27)
For safety and health reasons, the saw cover must be connected to a dust extraction system. This
must have a flow rate of min 1200m³ / h at 20 m / s.
The connection at the bottom of the saw unit has a diameter of 120 mm, on the saw guard (via the
support pipe) with a diameter of 100 mm. The saw guard itself must be set so that the saw blade and
the scoring blade are protected and the piece to be machined can be moved just under the cover.
The height adjustment of the hood is done by pulling back the pin (fig. 27, 2). With normal use
pull the pin (fig. 27,2) backwards and lower the saw blade onto the work table. The saw cover will
automatically raise when entering workpieces up to a certain thickness. For workpieces where a
larger cutting height is required: grasp the saw blade on the handle (4), pull the pin (2) back and place
the saw blade in the desired position. Push the clamping pin 2 forward again and the saw blade is
fixed. The saw cover can no longer lower, but will go up if a higher workpiece is inserted. To lock the
saw blade in both directions, screw in the clamp pin (fig. 27,1). To set a maximum cutting height,
place the ring (3) in the desired position.
The saw blade has a narrow cover for sawing under 90 °. To place it, slide the plate (fig 26A, 1) down
into the key holes and attach the 2 clamp screws (26A, 2).
The wide hood serves for cutting under 45 °. This is also fixed with 2 clamping screws (fig 26B, 2) and
also slides into 2 key holes.