81
15.1 --> Enable contacts CN12 as REMOTE
ON / OFF or as TBH ON / OFF;
15.2 --> Enable a SMART GRID;
15.3 --> Enable option 2 HIGH / LOW
temperature ZONES;
15.4 --> Enable the inertial storage temperature
probe (only for cascade unit function)
15.5 --> Enable additional DHW storage tank
temperature probe
15.6 --> Sets the position of the room
temperature probe (to use the user interface as
a thermostat, set to "HMI")
15.7 --> Sets the offset of the room
temperature read by the user interface.
15.8 --> Enable the solar option. ONLY SOLAR
(the DHW is heated by the solar option only).
SOLAR + HP (DHW is produced by both solar
and heat pump);
15.9 --> The length of the piping between the
indoor unit and the outdoor unit
15.10 --> Enables external temperature control
(not available for this version)
15.11 --> Limits the internal pump of the unit
(not available for this version)
15.12 --> Defines what type of signal contacts
DFT1/DFT2 should manage (defrosting; alarm).
Size. No. 0
1
2
3
4
5
6
7
8
HS004 - HS006
18 18 16 15 14 13 12 12 12
HS008 - HS010
19 19 18 16 14 12 12 12 12
HS012 - HS014
(1-phase)
30 30 28 26 24 22 20 18 16
HS016 (1-phase)
30 30 29 27 25 23 21 19 17
HS012 - HS014
(3-phase)
14 14 13 12 11 10
9
9
9
HS016 (3-phase)
14 14 13 12 11 10
9
9
9
PPO
OW
WEERR IINNPPU
UTT LLIIM
MIITTAATTIIO
ONN
M
MEENNU
U >> FFO
ORR SSEERRVVIICCEEM
MAANN >> PPO
OW
WEERR IINNPPU
UTT
LLIIM
MIITTAATTIIO
ONN
How to set the POWER INPUT LIMITATION
15.12 DFT1/DFT2
DEFROST
15.11 PUMP_I SILENT MODE
YES
Ta-adj
-3 °C
SOLAR INPUT
NO
F-PIPE LENGTH
>=10m
Sets the type of power input limitation and the setting
range is 0-8.
If the unit will operate at larger power input, 0 should
be selected.
If the unit will operate at a lower power input, 1-8
should be selected and the power input and capacity
will decrease.
IINNPPU
UTT DDEEFFIINNEE
M
MEENNU
U >> FFO
ORR SSEERRVVIICCEEM
MAANN >> IINNPPU
UTT DDEEFFIINNEE
How to set the INPUT DEFINE
M1/M2
Tw2
StaRt - up
