Ricoh VT3500, Service Manual

Page: 201 / 330

16. Distribute ink on the drum.
a. Press the Reset key [A] while holding down the "0" key [B] on the
operation panel.
b. If blinks on the operation panel when the machine stops, press the
Reset key again.
17. Make test prints once the machine is installed.
a. Adjust the original guide [C] to match the original size.
b. Set the original face down on the original feed table.
c. Press the Master Making key [D].
d. Select the lowest print speed (1) with the Speed key [E] and press the
Print Start key [F]. Make prints at this speed until the print image
density stabilizes.
NOTE: 1. Usually, about 100 prints are made before the image fully
stabilizes.
2. Check image quality after the print image density is stabilized.
18. Enter telephone number using SP mode No. 152. The number will be
displayed when a Service Call Code is lit.
[A]
[D]
[B]
[E]
[F]
[C]
1 December 1993
3-9