BIT SWITCHES
21 May, 1999
4-18
G4 Communication Parameters
Compression mode
MMR: MMR compression
MR: MR compression
MH: MH compression
Resolution
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
24: Fine (200 x 400 dpi)
Width and reduction
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction (tx only)
A3: A3 (11.7"), no reduction (tx only)
Transfer
T: Transfer, - : Other
Confidential
C: Confidential, - : Other
Other parameters
The following information is shown in 6-bit format. Bit 1 is the
first bit from the left, and bit 6 is at the right end.
Bit 1 - Smoothing
0: Enabled, 1: Disabled
(Smoothing is disabled in halftone mode.)
Bit 2 - CIL printing
0: Enabled, 1: Disabled
Bit 3 - Not used
Bit 4 - mm/inch conversion
0: Disabled, 1: Enabled
Bit 5 - Engine type
0: mm, 1: inch
Bit 6 - Resolution unit
0: mm, 1: inch
System Switch 01
No
FUNCTION
COMMENTS
0
PM call
0: Disabled 1: Enabled
This bit switch determines whether the machine
will send an Auto Service Call to the service
station when it is time for PM.
1-7
Not used
Do not change these settings.
System Switch 02
No
FUNCTION
COMMENTS
0
Memory file transfer
0: Disabled
1: Enabled
1: All messages in the memory (including
confidential RX messages) are sent to the fax
number that is stored as the service station.
Always reset this bit to zero after transfer.
Cross-reference
Service station number: Function 13
1-5
Not used
Do not change these settings.
6
7
Memory read/write by RDS
Bit 7 6 Setting
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked
out, but the user can temporarily switch RDS on
to allow RDS operations to take place. RDS will
automatically be locked out again after a certain
time, which is stored in System Switch 03 (see
below). Note that if an RDS operation takes
place, RDS will not switch off until this time limit
has expired.
(1,1): At any time, an RDS system can access
the machine.
