BIT SWITCHES
21 May, 1999
4-20
System Switch 07 - Not used (do not change any of these settings)
System Switch 08 - Not used (do not change any of these settings)
System Switch 09
No
FUNCTION
COMMENTS
0
Not used
Do not change this setting.
1
Inclusion of communications in
the Journal when no image
data was exchanged.
0: Disabled 1: Enabled
0: The Journal lists communications that
reached phase C (message TX/RX) of the T.30
protocol.
1: The Journal lists communications that
reached phase A (call setup) of T.30 protocol.
This includes telephone calls.
2
Automatic error report printout
0: Disabled 1: Enabled
0: Error reports are not printed.
1: Error reports will print automatically after all
failed communications, excluding polling
reception and immediate transmissions.
3
Print error code on error report
0: No 1: Yes
1: Error codes are printed on the error reports.
4
Listing of Confidential IDs on
the Personal Code List
0: Disabled 1: Enabled
1: Confidential IDs registered with Personal
Codes by the users will appear on the Personal
Code List.
5
Power failure report
0: Disabled 1: Enabled
1: A power failure report automatically prints
after the power is switched on if a fax message
disappears from memory when the power was
turned off last.
6
Conditions for printing the
protocol dump list
0: Print for all communications
1: Print only when there is a
communication error
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
protocol dump list only for communications with
errors.
7
Priority given to various types
of remote terminal ID when
printing reports
0: RTI > CSI > Dial label >
Tel. Number
1: Dial label > Tel. number >
RTI > CSI
This bit determines which set of priorities the
machine uses when listing remote terminal
names on reports.
Dial Label: The name stored with the
Quick/Speed Dial number by the user.
System Switch 0A
No
FUNCTION
COMMENTS
0
Not used
Do not change these settings
1
Default communication mode
0: G3
1: G4
These bits determine the machine's standby
default communication mode if a G4 option has
been installed.
2
Not used
Do not change these settings.
