SERVICE LEVEL FUNCTIONS 21 May, 1999
4-12
4.1.25 SRAM DATA UPLOAD (FUNCTION 12)
This function copies all the data stored in the SRAM on the FCU inside the
machine to the Flash memory card. Use this before replacing a damaged FCU to
save programmed settings.
1. Turn off the machine.
2. Connect the Flash memory card and the software copy tool as shown in section
4.1.22.
NOTE: The switch on the copy tool must be at the OFF position.
3. Turn on the machine.
4.
òñ
ç
ì
ä
ä
å
then immediately press
ú
5.
ì
ë
ú
6.
õ
ç
7.
÷
If the SRAM data uploads successfully,
the display shows "OK".
If the SRAM upload fails, the display shows
"CANNOT PROGRAM".
8. Finish :
òñ
9. Turn off the machine and disconnect the tool. Then turn the machine back on.
4.1.26 SRAM DATA DOWNLOAD
This function copies the data stored in an external Flash memory card to the FCU
inside the machine. Use this after replacing a damaged FCU to save any
previously programmed settings.
1. Turn off the machine.
2. Connect the Flash memory card and the Flash memory copy tool as shown in
section 4.1.22.
NOTE: The switch on the copy tool must be at the OFF position.
3. Turn on the machine.
4.
òñ
ç
ì
ä
ä
å
then immediately press
ú
5.
ì
ë
ú
6.
õ
è
FUNCTION KPAD/NEXT>
■■
SERVICE FUNCTIONS
OK!!
COPY MACH -> SRAM
0-SRAM 1-SAF
2-SAFCARD 3-M->R
FUNCTION KPAD/NEXT>
■■
SERVICE FUNCTIONS
0-SRAM 1-SAF
2-SAFCARD 3-M->R
OK!!
COPY MACH <- SRAM
