BIT SWITCHES
21 May, 1999
4-34
Communication Switch 13
No
FUNCTION
COMMENTS
0
to
7
Immediate transmission:
Interval between dialing
attempts to the same
destination
00 - FF (Hex) minutes
Communication Switch 14
No
FUNCTION
COMMENTS
0
mm-to-inch conversion during
transmission
0: Disabled (default)
1: Enabled
0: Transmitting is always done in mm format.
1: If the other end only has inch-based
resolution for printing, the machine converts the
scanned data to inch-format before
transmission.
Other models use inch-based scanning. In these
models, this setting is inch-to-mm conversion.
1-7
Not used
Do not change the settings.
Communication Switch 15 - Not used (do not change any of these settings)
Communication Switch 16
No
FUNCTION
COMMENTS
0-1
Not used
Do not change the settings.
2
Optional G4 unit
0: Not installed
1: Installed
1: Change this bit to 1 when installing the
optional G4 unit.
3-5
Not used
Do not change the settings.
6
ISDN G3 Reception
0: Enabled
1: Disabled
1: Disables ISDN G3 reception
7
Not used
Do not change the settings.
Communication Switch 17
No
FUNCTION
COMMENTS
0
SEP (selective polling)
reception
0: Disabled 1: Enabled
0: Disables the SEP (selective polling) signal
reception.
1
SUB reception
0: Disabled 1: Enabled
0: Confidential reception to another maker’s
machine using the SUB (Sub-address) signal is
disabled.
2-7
Not used
Do not change the settings.
Communication Switch 18 - Not used (do not change any of these settings)
Communication Switch 19 - Not used (do not change any of these settings)
Communication Switch 1A - Not used (do not change any of these settings)
