Ricoh B022, Service Manual, Page: 785 / 878

Tech Service Bulletin No. B022/B027 – 015
Page 3 of 4
5. Necessary UP Settings:
UP Mode:
Users need to perform the necessary settings (Capture server IP address, etc.) from inside: [Use
Tools/Counter]
Æ [System Settings].
Please refer to the Operating Instructions for the procedure.
5.1 Copier UP Mode Explanation:
Users need to perform the necessary settings; user tool/system settings/file transfer/ Capture
server IP address, eCabinet IP address.
On the copier go to; user tools/system settings/key op tools/next button/capture priority.
On the copier go to; user tools/system settings/timer settings and set to customer's preference.
Explanation:
• “OFF”: Normal mode - eCabinet window does not pop up and there is no capture to eCabinet.
• "OFF" Default: - eCabinet window pops up, select ecab user, and choose capture "ON" or OFF."
"ON" Default: - eCabinet window pops up, select ecab user, and choose capture "ON" or OFF."
• "ON": - eCabinet window pops up, user must be selected, and capture mode is "ON" and can
not be changed.
• "ON" NO DISPLAY: - eCabinet window and capture happens behind the scenes. Default user
setup on.
eCabinet under settings/advanced settings/capture control will always be the captured documents
owner.
Example:
Capture priority for copier is set for default “ON.” This way the eCabinet window pops up every
time Copier mode is used and the capture button is selectable.
5.2 To Configure the Copier:
1. Install the copier on the network and press the User Tools/Counter button.
2. On the User Tools/Counter screen, press System Settings
3. Press the File Transfer tab.
4. Press Capture Server IP Address, and enter the eCabinet IP address. Press OK to apply.
5. Press the Interface Settings tab, and enter the network information for the copier.
6. Press the Exit button to save the settings.
Continued…