Ricoh B022, Service Manual, Page: 640 / 878

BIT SWITCHES
B418 3-18 SM
System Switch 1D SP No. 1-101-030
No FUNCTION COMMENTS
0 RTI/CSI/CPS display
0: Disabled
1: Enabled
1: RTI/CSI/CPS is displayed on the top line of the
LCD panel during communication.
1-7 Not used Do not change the settings.
System Switch 1E SP No. 1-101-031
No FUNCTION COMMENTS
0 Communication after the
Journal data storage area has
become full
0: Impossible
1: Possible
This setting is effective only when Automatic Journal
printout is enabled but the machine cannot print the
report (e.g., no paper).
0: If the buffer memory of the communication
records for the Journal has become full, fax
communications will become impossible, to prevent
overwriting the communication records before the
machine prints them out.
1: If the buffer memory of the communication
records for the Journal is full, fax communications
are still possible. But the machine will overwrite the
oldest communication records.
Cross Reference
Automatic Journal output - User switch 03 bit 7
Number of communication records for the
Journal:
200 records (standard)
1000 records (with the Function Upgrade unit
installed)
1 Action when the SAF memory
has become full during
scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during scanning,
the successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning,
the file is erased and no pages are transmitted.
This bit switch is ignored for parallel memory
transmission.
2 RTI/CSI display priority
0: RTI 1: CSI This bit determines which identifier, RTI or CSI, is
displayed on the LCD while the machine is
communicating in G3 non-standard mode.
3 File No. printing
0 : Enabled
1 : Disabled
1: File numbers are not printed on any reports.
4 This switch allows or prohibits
all fax reception when
Authorized Reception is
enabled and no RTI/CSI’s have
been programmed.
0: All fax receptions are
enabled.
1: All fax receptions are
disabled.
This switch is only effective when Authorized
Reception is enabled and there are no RTI/CSI’s
programmed.
Under these two conditions:
The default setting of “
0 ” allows the machine to
receive all incoming faxes. This is useful in cases
where the customer has mistakenly enabled
Authorized Reception with no RTI/CSIs
programmed. Setting this switch to “1” will cause
the machine to reject all incoming transmissions.
⇒
Rev. 04/2004