Ricoh B022, Service Manual, Page: 633 / 878

F
ax Un
it
B418
BIT SWITCHES
SM 3-11 B418
I/O rate 0: 0 ms/line 10: 10 ms/line
25: 2.5 ms/line 20: 20 ms/line
5: 5 ms/line 40: 40 ms/line
Note:
“40” is displayed while receiving a fax message using AI short
protocol.
G4 Communication Parameters
Compression mode MMR: MMR compression
MR: MR compression
MH: MH compression
Resolution 21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
44: Superfine (400 x 400 dpi)
Width and
reduction A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
Transfer T: Transfer
- : Other
Confidential C: Confidential
- : Other
Other parameters
The following information is shown in 6-bit format. Bit 1 is the first
bit from the left, and bit 6 is at the right end.
Bit 1 - Smoothing 0: Off, 1: On
(Smoothing is disabled in halftone mode.)
Bit 2 - CIL printing 0: On, 1: Off
Bit 3 - Not used
Bit 4 - mm/inch conversion 0: Off, 1: On
Bit 5 - Engine type 0: mm, 1: inches
Bit 6 - Document resolution unit 0: mm, 1: inches
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02 SP No. 1-101-003
No FUNCTION COMMENTS
0-3
Not used Do not change the settings.
4 File retention time
0: Depends on User Parameter
24 [18(H)]
1: No limit 1: A file that had a communication error will not be
erased unless the communication is successful.
5
Not used Do not change the setting.