Ricoh A151, Field Service Manual

Page: 69 / 397

2.2 SERVICE PROGRAM MODE TABLE
1. A "
❐
" after the mode name means that copies can be made while in the
SP mode. (Copies can be made by pressing the Start key after pressing
the Auto Image Density key.)
2. In the Function column, comments (extra information) are in italics.
3. In the Data column, the default value is printed in bold letters.
4. In some SP modes, data display is different between the FT3013 and
FT3213 models because of the difference in the operation panel. After
entering the desired SP mode number, refer to the notes written at the
end of the table to correctly observe the displayed data. (Which note to
refer is described inside the Function column.)
Mode No. Function Data
5 Exposure Lamp
OFF
❐
Exposure lamp OFF
Turn on DPS101-1, then press the Start key to
start free run. Press the C/S key to stop free run.
Press the Auto Image Density key in Ready
mode to turn off this mode.
Use this mode for the scanner movement check.
To save toner, remove the development unit.
6 Misfeed
Detection Off
❐
Copies are made without misfeed detection.
Press the Start key to make a copy. Press the
Auto Image Density key in Ready mode to turn
off this mode.
Use this mode to check whether the paper
misfeed was caused by a sensor malfunction.
The total counter increments when copies are
made in this mode.
7 Aging Mode Factory use.
8 Input Check
❐
Displays the input data from sensors and
switches. For data, see
page 4-20.
9 Output Check Electrical components turn on. For data, see
page 4-21.
11 All Indicators
ON Turns on all the indicators on the operation panel.
To turn off the indicators, press the Auto Image
Density key.
12 220-230V/240V
Conversion Selects 220-230 or 240 volts. 0: 220-230V
1:240V
If the rated voltage is 240V, this data must be
changed to "1". Refer to NOTE 2.
14 Auto "OFF" Auto-off mode can be selected 0: 30 mins
(default)
1: 15 mins
2: 1 hour
3: 1.5 hours
4: 2 hours
15 Auto Reset
Time (Energy
Saver Mode) Selects auto reset time of 1 or 3 minutes, or
cancels this mode. 0: 1 min.
1: 3 min.
2: None
The copier automatically goes to the energy
saver mode at the selected reset time when
SP78 is set to "1".
16 Count Up/Down Selects count up or count down. 0: Up
1: Down
17 Open No function.
18 Reduce/Enlarge
Key Function
(FT3213 copier
only) Specifies whether reduction or enlargement is
selected first when the Reduce/Enlarge key is
pressed. 0: Reduction
1: Enlargement
Rev. 1/26/96
⇒
SER
V
IC
E
T
ABL
E
S
FSM 4-13 A151/A152