Ricoh A151, Field Service Manual

Page: 321 / 397

Mode No. Function Settings
80
Horizontal Edge
Margin Width
Adjustment Selects whether the side erase mechanism
changes when the optional document feeder is
installed. 0: Always stays
in Platen Mode
1: DF Mode
Compared with the platen mode erase, the next
inmost LED block will turn on to erase.
81
Factory
Initialization Factory use only.
Do not change the setting.
83
Toner End
Counter Clear Clears the toner end counter (SP58). Resets the
used toner overflow condition (E70) if it is
detected. 0: No
1: Yes
This mode must be performed when the used
toner tank is cleaned.
86
Energy Saving
Ratio Selects the energy saving ratio. 0: 56%
1: 47%
2: 37%
3: 25%
The greater the saving ratio, the longer the
waiting time until the copier returns to the ready
condition.
Saving Ratio
Waiting Time
0: 56% 25 s
1: 47% 19 s
2: 37% 12 s
3: 25% 5 s
95
V
L
Correction
Reset
Resets the exposure lamp setting and counter
for the V
L
correction.
0: No
1: Yes
Before performing this mode, clean the optics
parts. After performing this mode, perform SP48
and SP56.
96
Toner End
Force Cancel The Toner End condition is canceled forcibly.
By pressing the
key to enter this SP mode,
the toner end condition is canceled.
97
Service Call
(E5) Reset Resets a service call (E5) condition.
Turn the main switch off and on to check if the
service call condition is reset. 0: Default
1: Reset
98
Clear Counters Clear the following counters:
Copy counters
SC counters
Misfeed counters
To clear, enter "1" then press the key and
the key at the same time.
To avoid resetting the counter by mistake, the
counter is reset only when the
key and the
key are pressed at the same time.
0: No
1: Yes
99
Clear All
Memory Clear all counters and returns all modes to the
default settings. See the Clear All Memory
Procedure in this section for more details.
To clear, enter "1" then press the
key and
the key at the same time.
To avoid resetting the counter by mistake, the
counter is reset only when the
key and the
key are pressed at the same time.
0: No
1: Yes
Rev. 7/97
A202/
A203
Co
p
ier
SERVICE PROGRAM MODE
SM 8-43 A202/A203