Hold-o-mat
®
– Operating instructions
61
E
Additions Hold-o-mat 2/3, Standard, Big
The operating instructions Hold-o-mat, page 43 – 60 are also valid for Hold-o-mat 2/3, Standard
and Big. Please note the following additions:
Page 51, keyword «Operation, operating»
Use the
or
buttons to set the desired temperature. The indicator always shows the
actual temperature. By pushing an arrow button once, the desired temperature is displayed for two
seconds. Then the indicator returns to showing the actual temperature. By pressing the buttons
again while the desired temperature is displayed, the desired temperature can be increased or
decreased.
Page 57, keyword «In case of technical problems, The heating indicator lights but ...»
1. Switch off the unit using the
button and disconnect from the power supply.
2. Remove the plug near the heat cut off sticker
on the rear end of the unit.
3. Push the reset button on the cut off with a screwdriver.
4. Replace the plug in the rear end.
5. Connect to the power supply and switch on.
6. If the overheating cut out engages again, consult your nearest service centre.
Replenishment Hold-o-mat Big
Everywhere the operating instructions mention door or door seal:
For the Hold-o-mat Big, it concerns both doors / door seals.
Page 47, keyword «Placement requirements»
... such as kitchen, restaurant, party service etc. Use the carrying handles only when the total
weight (unit-weight 41 kg plus content weight) is less than 70 kg. Use all four handles equally and
avoid jerky movements.
Main switch – on/off
Heat indicator
Increase temperature
Temperature indicator
Lower temperature
Panel Hold-o-mat 2/3, Standard, Big
